Connecting The Speakers; Connecting Antennas - Pioneer X-HM81-S Guide Rapide

Connecting the speakers

Be sure to complete all connections before connecting this receiver to the AC power
source.
Right speaker Left speaker
SPEAKERS
A
L
AM
LOOP
R
FM
UNBAL
75Ω
Connecting a TV and playback component
3
1
WLAN ANTENNA
2
TV
(commercially available)
To AC outlet
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by PIONEER CORPORATION is under license.
®
Other trademarks and trade names are those of their respective owners.

Connecting antennas

Connect the supplied WLAN antenna as
show above.
Connect the FM wire antenna and the AM
loop antenna as shown below.
AM loop
antenna
SPEAKERS
ANTENNA
FM wire
AM
LOOP
antenna
FM
UNBAL
75Ω
LAN (10/100)
Make sure you connect the speaker on the
right to the right (R) terminal and the speaker
on the left to the left (L) terminal. Also make
sure the positive and negative (+/–) terminals
on the receiver match those on the speakers.
You can use speakers with a nominal
impedance between 4 Ω and 16 Ω.
1. If not using the provided speaker wire,
twist exposed wire strands together.
2. Loosen terminal and insert exposed
wire.
3. Tighten terminal.
1
10 mm
Supplied WLAN antenna
WLAN ANTENNA
WLAN ANTENNA
To video input
socket
VIDEO
OUT
ADAPTER PORT
Video cable
X-HM81
Connect Bluetooth
Power cord
technology ADAPTER AS-BT100 or
AS-BT200 (sold separately)
Connecting your iPod/iPhone/iPad
or USB device
Connect your iPod/iPhone/iPad or USB
device to the USB/iPod/iPhone/iPad terminal
on the front panel.
STANDBY/ON
INPUT
PHONES
USB mass
storage device
L
R
USB cable provided with iPod/iPhone/iPad units, or
a commercially available USB cable to support iPod/
iPhone/iPad (for iPod connection)
2 3
SPEAKERS
ANTENNA
LINE SUBWOOFER AM
LOOP
L
FM
UNBAL
75Ω
R
IN PRE OUT
(OUTPUT 5V 0.1 A MAX)
LAN (10/100)
XC-HM81
wireless
®
VOLUME
NET STANDBY/
POWER CHARGE TIMER
USB
AUDIO IN iPod/iPhone/iPad
iPod/iPhone/
iPad
CAUTION
• These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent
the risk of electric shock when connecting
or disconnecting the speaker cables,
disconnect the power cord before touching
any uninsulated parts.
• Make sure that all the bare speaker wire
is twisted together and inserted fully into
the speaker terminal. If any of the bare
speaker wire touches the back panel it
may cause the power to cut off as a safety
measure.
Red tube
X-HM81 and X-HM71
provided speaker wire
Modem
L
Internet
Router
R
LAN
3 2
PC
LAN cable
(commercially available)
Connecting your iPod/iPhone to
the docking station
1. Open the dock cover by pulling up.
2. If you have the Universal dock adapter, attach
it to iPod/iPhone connector port.
3. Connect your iPod/iPhone.
iPod/iPhone (bottom)
Dock connector
iPod/iPhone connector
1
WAN
To LAN
port
iPod/iPhone
3
En