Replacing Controller | Regulator - Kemper FK-5 Instructions D'entretien

10

Replacing controller | regulator

Controller | regulator for DN 20 | DN 25
DN 20
Art. No.: 3691700100
DN 25
Art. No.: 3691700200
This work may only be carried
out by a qualified electrician!
Attention!
All settings will be lost! If necessary, make a note
of all system-specific configurations (pump cut-in
pressure, flushing operation times and enabled
accessories).
1
Danger!
Disconnect the system from the power supply!
2
Open the controller housing using a flat-headed screwdriver.
3
Disconnect all connected cables. First note the assignments!
4
Pull all of the cables out of the housing.
5
Loosen the four M4 Allen bolts in the corners of the housing
and remove the controller.
6
Install the new controller and bolt it in place.
7
Reconnect all disconnected cables of the add-on parts according to
the instructions.
Power supply for the system 1; 2; 3
Temperature sensor 33; 34
Level sensor 30; 31; 32
8
Close the housing and connect the system to the power supply.
9
Perform all of the necessary settings again and put the system
into operation according to the instructions (see Operating
Instructions).
© www.kemper-olpe.de – K41003690008-00 / 04.2022 – 27 /88
Power supply for the pump 5; 6; 7
Pressure sensor 27; 28;29
Inlet 1: 17; 18; 19; 20