Kemper FK-5 Instructions D'entretien page 16

EN
Safety instructions for installation and maintenance
Table of Contents
Safety instructions
These instructions describe the replacement of
different components of the station
1 Replacing pump
2 Replacing the pressure transmitter pump pressure
3 Replacing pressure transmitter fullness level
4 Replacing solenoid valve
5 Replacing check valve
6 Replacing cone for check valve
7 Replacing quarter turn stop valve
8 Replacing bonnet for quarter turn stop val
9 Replacing servo drive
10 Replacing controller | regulator
11 Replacing pump relay for regulator
Installation and usage
Read the manual carefully and follow the instructions before
installation!
Pass these instructions on to the system operator and retain for later
reference!
Warning! Installation and maintenance is to be done only by
competent and qualified professionals qualified for sanitary
plumbing. Electrical installation only by a qualified electrician!
Warning! Priority must be given to the national standards and
provisions on sanitary installations and accident prevention.
Warning! Non-compliance with the instructions
in the course of assembly, use and maintenance can endanger
proper operation and lead to substantial damage to health through
mixing drinking water with non-potable water.
Labelling of important warning information:
Danger!
Electricity! Indicates hazards that may result in severe or
fatal injury.
Warning!
Indicates hazards that may result
in injury, damage to property or
contamination of drinking water.
Note!
Indicates hazards that may result
in damage to the system or malfunctions.
Info
Indicates additional information and tips.
16 /88 - K41003690008-00 / 04.2022 - © www.kemper-olpe.de
Damage to property due to improper use and/or unsuitable
tools
16
Improper use and/or unsuitable tools can result in damage to
property (e.g. due to water leakage)! When tightening or loosening
17
screw connections, always use the right open-ended wrench or
18
pliers wrench. To avoid leaks, make sure that no mechanical stress
19
arises in the pipelines and components.
20
21
22
Danger! When working on live components, the system
23
must always be switched off circuit.
24
25
Note! Before working on the controller, ensure that you
26
are not electrostatically charged.
27
28
Liability
No warranty or liability can be accepted in case of:
• Non-compliance with the instructions.
• Incorrect installation and/or operation.
• Unauthorised modification of the product.
• Other incorrect operation.
Disposal
Local regulations on waste recycling and disposal must
be followed. The product must not be disposed of with
household waste but must be disposed of properly.