Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing the Exterior Wall Vent
For maximum functionality and comfort the supplied vent duct kit should ble placed close to the floor in the area behind the
toilet (fig. 12). Note: The vent duct could also be placed elsewhere in the room, as long as there are no other air dependent
installations close by and that there is a door or similar that preserves the air inside the room.
1. Drill four pilot holes in a 6
the drill perpendicular to the floort (fig. 13)
2. Use a jigsaw to cut between the four holes (fig. 14).
3. Mount the expandable vent duct kit (fig. 15/16).
Warning: Before cutting any holes, always check that you will not hit any electrical wiring or water pipes. Failure to
follow safety precautions may cause serious injury or death.
Fig. 12
Fig. 14
6
13/32
in.
7 in.
(163 mm)
(178 mm)
Fig. 16
in (159mm) square with a long drill bit through the wall. Make sure you are holding
1/4
6 in.
(152 mm)
6
5/32
in.
7 in.
(156 mm)
(178 mm)
6
in.
1/4
(159 mm)
Fig. 13
2
Fig. 15
4
21/32
in.
(118-210mm)
7 in.
(178 mm)
x4
1
6
13/32
in.
7 in.
(163 mm)
(178 mm)
11
Publicité
Table des Matières
