Setting The Speed-Dependent; Volume Increase (Auto Snd); Setting The Bass Increase (Xbass); Confi Guring The Preamplifi Er Output For The Subwoofer (Subout) - Blaupunkt St. Louis MP56 Notice D'emploi Et De Montage

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 65
Press the softkey located next
to the desired sound preset.
The selected sound preset is
highlighted and shown on the
A
main line
.
To turn the equalizer off, press
:
the softkey
OFF").

Setting the speed-dependent

volume increase ( AUTO SND)
When you are driving faster, the
device can automatically increase
the volume to compensate for the
driving noise. In order for this to
work, the speedometer signal
must be connected as described
in the installation instructions.
You can adjust this volume in-
crease from 0 (no increase) to 5
(maximum increase).
Repeatedly press the softkey
9
(next to "AUTO SND").
The current speed-dependent
volume increase is shown on
the main line
Note:
If no increase is set, the main
A
line
shows "AUTO SND OFF".
On the rocker switch
or
to raise the volume in-
crease.
On the rocker switch
or
to lower the volume in-
crease.
Changing basic settings in the settings menu
(next to "P-EQ
A
.
3
, press
3
, press
Setting the bass increase ( XBASS)
XBASS is a bass increase at low
volume. This bass increase can be
set in increments from 0 (no in-
crease) to 6 (maximum increase)
for the following frequencies:
32 Hz, 40 Hz, 50 Hz, 63 Hz, or 80 Hz.
Press the softkey
"XBASS").
The "XBASS" menu item is
fl ashing. The frequency (Hz)
and bass increase (GAIN) are
shown on the main line
On the rocker switch
or
to select the desired fre-
quency.
On the rocker switch
or
to set the desired bass
increase.
Confi guring the preamplifi er out-
put for the subwoofer ( SUBOUT)
If you want to use an additional
subwoofer, it can be adjusted to
the other loudspeakers.
You can adjust the level of the
Subout preamplifi er output in
13 increments from –6 dB (max-
imum decrease) to +6 dB (maxi-
mum increase) for one of the fol-
lowing cut-off frequencies: 80 Hz,
120 Hz, or 160 Hz.
In the "AUDIO" menu, press the
:
softkey
(next to "SUBOUT").
;
(next to
A
.
3
, press
3
, press
45

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

7 646 590 310

Table des Matières