Setting The Colour Of The Display Illumination; Setting A Colour For The Display Illumination; Selecting The Colour Of The Display Illumination Using The Colour Scan - Blaupunkt Key West MP36 Notice D'emploi Et De Montage

DISPLAY COLOUR
Setting the colour of the
display illumination
You can adjust the colour of the display
illumination to suit the illumination of
your vehicle cockpit.
KEY WEST MP36: The primary colours
red, green and blue (R-G-B) are
available for this. Each colour provides
values from 0-16.
MAUI MP36: The primary colours red
and green (R-G) are available for this.
Each colour provides values from 0-4.
Setting a colour for the display
illumination
➮
Press the MENU button 9.
➮
Press the or
edly until "DISP COL" appears in
the display.
➮
Press the or
The menu for setting the colours is dis-
played. "R", "G" and "B" ("B" only KEY
WEST MP36) are displayed with the
current values. The "R" setting flashes.
➮
Press the or
edly until the setting that you want
is displayed after "R".
➮
Press the or
move the selection cursor to the
position of the other colours ("G" or
"B").
➮
Adjust the other colours to suit your
preferences.
When you have finished making your
changes,
➮
press the MENU button 9 twice.
The settings are saved.
26
button : repeat-
button :.
button : repeat-
button : to
Selecting the colour of the
display illumination using the
colour scan
You can select the colour of the display
illumination during the colour scan. The
display shows all the possible colour
variations that are available in the RGB
or RG (MAUI MP36) spectrum. The
colour scan takes approx. 40 seconds.
➮
Press the MENU button 9.
➮
Press the or
repeatedly until "COL SCAN"
appears in the display.
➮
Press the or
The colour scan starts. All the possible
colour variations that are available in the
spectrum are shown in the display one
after another.
If you want to select the display illumi-
nation colour that is currently being
shown,
➮
press the MENU button 9.
The settings are saved.
If you want to cancel the colour scan
without setting a new colour,
➮
press the or
Note:
If you do not press a button, the
●
colour scan will stop after cycling
through the colours once (approx.
40 seconds) and the previously
selected colour will be applied as
the setting again.
button :
button :.
button :.