Electrical Safety; Noise Information - Bosch GRL 400 H Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FCC Statement
This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Declaration of Conformity
We declare under our sole responsibility that the product described under "Technical Data" is in conformity with the
following standards or standardization documents: EN 61010-1, EN 60825-1 (measurement tool) according to the
provisions of the directives 2006/95/EC, 2004/108/EC, 2006/42/EC.
Work area safety
Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
DO NOT operate the laser tool around children or
allow children to operate the laser tool. Serious
eye injury could result.

Electrical safety

B a t t e r i e s
!
WARNING
o r
or fire. To reduce this risk, always follow all
instruct-ions and warnings on the battery label
and package.
D O N O T s h o r t a n y b a t t e r y t e r m i n a l s .
D O
N O T
c h a r g e
DO NOT mix old and new batteries. Replace
a l l o f t h e m a t t h e s a m e t i m e w i t h n e w
b a t t e r i e s o f t h e s a m e b r a n d a n d t y p e .
D O
N O T
m i x
Dispose of or recycle batteries per local code.
D O N O T d i s p o s e o f b a t t e r i e s i n f i r e .
K e e p b a t t e r i e s o u t o f r e a c h o f c h i l d r e n .
Remove batteries if the device will not be used for
several months.
Personal safety
Stay alert, watch what you are doing and use
common sense when operating a tool. Do
not use a tool while you are tired or under
the influence of drugs, alcohol or medication.
A moment of inattention while operating a tool
SAVE THESE INSTRUCTIONS
c a n
e x p l o d e
l e a k ,
c a u s e
a l k a l i n e
b a t t e r i e s .
b a t t e r y
c h e m i s t r i e s .
may result in serious personal injury or incorrect
measurement results.
Use safety equipment. Always wear eye
protection. Safety equipment such as dust mask, non-
skid safety shoes, hard hat, or hearing protection used
for appropriate conditions will reduce personal injuries.
!
WARNING
when dropped, broken glass can cause laceration
i n j u r y
hazard and unit to lose its IP rating. Contact
customer service immediately.
Measured sound values determined according to EN
60745.
Typically the A-weighted sound pressure level of the
measuring tool is less than
70 dB(A).
Use the correct tool for your application. The correct
tool will do the job better and safer.
Do not use the tool if the switch does not turn it
on and off. Any tool that cannot be controlled with the
switch is dangerous and must be repaired.
Store idle tool out of the reach of children and do
not allow persons unfamiliar with the tool or these
instructions to operate the tool. Tools are dangerous
in the hands of untrained users.
-6-
If glass light house breaks

Noise Information

Use and care

Publicité

Table des Matières
loading

Table des Matières