Safety Rules For Tile Saws - Bosch TC10 Consignes De Fonctionnement/Sécurité

BM 2610019162 07-12_BM 2610019162 07-12.qxp 7/31/12 2:21 PM Page 3
"READ ALL INSTRUCTIONS" — Failure to follow the SAFETY RULES identified by
WARNING
BULLET (•) symbol listed BELOW and other safety precautions, may result in serious
personal injury.
and safer at the rate for which it is designed. Do
not use the tool for purpose not intended - for
example; do not use the tile saw for slicing meats.
• Do not use tool if switch does not turn it "ON"
or "Off". Any tool that cannot be controlled with
the switch is dangerous.
• Disconnect the plug from the power source
before making any adjustments or changing
accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
• Keep cutting tools sharp and clean. Properly
maintained tools, with sharp cutting edges, are
less likely to bind and easier to control. When
mounting saw blades be certain that the arrow on
the blade matches the direction of the arrow
marked on the tool and that the teeth are also
pointing in the same direction.
• Inspect guards before using a tool. Keep
guards in place.
binding or any other condition that may affect
the normal operation or safety features of the
tool. If damaged, have tool serviced before
using the tool. Many accidents are caused by
poorly maintained tools.
• If any part of your saw is missing, malfunction-
ing, has been damaged or broken such as the
motor switch, or other operating control, a
safety device or the power cord cease operat-
ing immediately until the particular part is
properly repaired or replaced.
• Be certain the tile saw is mounted or placed on
a level, firm work surface before using. A level
and firm work surface reduces the risk of the tile
saw becoming unstable.
• To reduce the risk of electrocution, keep all-
connections dry and off the ground. Do not
touch plug with wet hands.
• A Ground fault Circuit Interrupter (GfCI) is
provided with the tile saw. GfCI does not pro-
tect against electrical shock due to contact
Check moving parts for

Safety Rules for Tile Saws

"SAVE THESE INSTRUCTIONS"
Safety
• Do not alter or misuse tool. Any alteration or
modification is a misuse and may result in serious
personal injury.
• The use of any other accessories not speci-
fied in this manual may create a hazard.
Accessories that may be suitable for one type of
tool, may become hazardous when used on an
inappropriate tool.
• Tool service must be performed only by qual-
ified repair personnel. Service or maintenance
performed by unqualified personnel may result in
misplacing internal wires and components which
could cause serious hazard.
• When servicing a tool, use only identical
replacement parts. follow instructions in the
Maintenance section of this manual. Use of
unauthorized parts or failure to follow Maintenance
Instructions may create a hazard.
with both circuit conductors or a fault in any
wiring supplying this device.
• Test GfCI before each use. Do not use tile saw
and have it serviced to correct malfunction if it
fails the GfCI test.
• Do not use extension cord unless tile saw is
plugged into outlet protected by GfCI.
• Use top guard for every operation for which it
can be used.
• Disconnect saw from power source before
making adjustments, servicing, cleaning, or
changing blade.
• Make sure the cutting tool rotates in the same
direction as the rotation arrow on the upper
guard.
-3-
Service