General Specifications - Klein Tools ET180 Manuel D'instructions

ENGLISH
Klein Tools ET180 is designed to measure the pressure for ports P1, P2,
and the differential pressure individually for air and gas pressures. The
meter features a magnet in back for hands-free operation.
• Environment: Indoors
• Sensor Type: Gauge manometer/dual sensors with temperature
compensation
• Range: +/- 60 inH
• Accuracy: +/- 1.5% FS at 25°C
• Measurement units: bar, oz/in
kg/cm , inH
2
2
• Auto Power Off (APO): After 15 minutes of inactivity
• Tubing: 1/8" ID × 6.56' (3mm ID × 2m) silicon tubing included
• Batteries: 3× AAA alkaline
• Operating Altitude: 6562 ft. (2000 m)
• Relative Humidity: <85% non-condensing
• Operating Temp: 32° to 122°F (0° to 50°C)
• Storage Temp: 14° to 140°F (-10° to 60°C)
• Dimensions: 6.19" × 2.47" × 1.38" (157 × 63 × 35 mm)
• Weight: 7.2 oz. (202 g) including batteries
• Standards: Conforms to EN 61326-1:2013; EN61326-2-3:2013
Specifications subject to change.
To ensure safe operation and service of the tester, follow these
instructions. Failure to observe these warnings can result in severe
injury or death. Know the characteristics of the gas you are working
with and use proper precautions to avoid hazardous conditions.
• Read, understand, and follow all instructions to ensure safe operation.
• The meter is NOT insulated. Avoid contact with areas where energized
conductive elements may be present. Shut off power to the area before
starting measurements.
• Always wear approved eye protection.
Warning or Caution
Wear Approved
Eye Protection
NOT insulated - Will NOT
protect against electric shock
Strong Magnetic Field
Read Instructions
2

GENERAL SPECIFICATIONS

O
2
O, ftH 0, and cmH
2
SYMBOLS ON METER
, psi, mbar, kPa, inHg, mmHg,
2
O
2
WARNINGS
Magnet Location
Conformité Européenne:
Conforms with European
Economic Area directives
UKCA - UK Conformity
Assessment
WEEE – Electronics disposal
Battery Type and Orentation