Functions - ESYLUX PD-C180i/16 UC Mode D'emploi

S1 button/remote control
The presence detector is equipped with a connection for an external
button. This can be used to manually switch the switching channel
on or off.
Manual switch-on – not in pulse mode!
Briefly press S1/remote control
switched on for as long as the detector continues to detect
movement. The predefined time setting will start once movement
is no longer detected. Once this time has elapsed, the lighting will
switch off and and the detector will revert to the set operating mode.
Manual switch-off – not in pulse mode!
Briefly press S1/remote control : the lighting will then remain switched
off for as long as the detector continues to detect movement.
The predefined time setting will start once movement is no longer
detected. Once this time has elapsed, the detector will revert to
the set operating mode.
6 • SETTINGS
"Short pulse" function
Once the detector has been triggered by movement, the channel
and the red LED will be switched on for 1 second and then off for
9 seconds.
Field of detection "test" function
The connected lighting is switched on - immediate, load-free
indication of movement given by 2 short flashes of the blue LED
(blue mode).
: the lighting will then remain
7 • FUNCTIONS
Fully automatic mode – not in pulse mode!
The light channel will switch on automatically, depending on the preset
light value and detection of movement. This will remain on for as
long as movement is detected and as long as the ambient light value
does not exceed the preset light value. If no further movement is
detected, the time setting starts. The channel can also be manually
switched on or off using the S1 button. The device is preset to fully
automatic mode.
Semi-automatic mode for light channel
Switched ON/OFF manually using the S1 button. This lighting will
remain switched on for as long as movement is detected and as long
as the ambient light value does not exceed the preset light value.
GB
11