ESYLUX PD-C180i/16 UC Mode D'emploi page 10

3 • INSTALLATION / ASSEMBLY / CONNECTION
Please observe the following before installing the device:
• Switch off the power supply before installing the product.
• Information relating to the detector's range is based on fig. 1
GB
as well as an ambient temperature of around 20°C
• Movements diagonal to the detector are ideal for triggering
the device (a direct and head-on approach makes it more
difficult for the device to detect movement and the range is
thus significantly reduced).
• The detector should be positioned according to spatial conditions
and requirements.
• Ensure that the detector has a clear line of sight, as infrared beams
cannot penetrate solid objects.
Install the device in the required position (fig. 2) and connect it as
shown in the circuit diagram (fig. 3).
4 • START-UP
Connect the power supply
• A warm-up phase of approx. 25 seconds is initiated.
The red (light channel) and the blue LED will flash alternately.
The connected lighting will be switched off during this time.
The detectors are preset to factory settings/remote control and are
therefore immediately ready for use after the warm-up phase.
10
overview of the factory settings
Light value for light channel Approx. 2,000 lux (daytime operation)
Time setting for light channel
Exit
Mode
5 • OPERATION
Depending on the preset light value, each time movement is detected
the red LED will briefly flash twice (the LED can be switched off –
see chapter 8/remote control). The presence detector operates
according to its default factory settings.
Delay – not in pulse mode!
The detector will only activate the lighting after a time delay to
prevent a sudden change in brightness from causing undesired
switching on/off of the lighting.
Time delay from "light to dark": 30 seconds =
red LED lights up for channel 1.
Time delay from "dark to light": 5 minutes =
red LED flashes slowly for channel 1.
The "blind" function interrupts the time delay from "light to dark"
if the light value falls below 50 lux and then switches the lighting
on at once.
Factory settings
Impulse feature
Make contact, light "OFF"
in start-up phase
Fully automatic