Functions - ESYLUX PD-C360i/8 UC Notice De Montage Et D'utilisation

Manual switch-off – not in pulse mode!
Briefly press S1/remote control
switched off for as long as the detector continues to detect
movement. The predefined time setting will start once movement is
no longer detected. Once this time has elapsed, the detector will
GB
revert to the set operating mode.
6 • SETTINGS
DIP switch (fig. 4)
DIP switch 1: "RC"/"manual"
The switch is set to "RC" in the factory settings. This means that the
device can be operated by remote control. Settings can only be
made using the relevant remote control.
"Short pulse" function
Once the detector has been triggered by movement, the channel
and the red LED will be switched on for 1 second and then off for
9 seconds.
Field of detection "test" function
The connected lighting is switched on - immediate, load-free
indication of movement given by 2 short flashes of the blue LED
(blue mode).
DIP switch 2: fully automatic (A)/semi-automatic (M)
DIP switch 2 is only active if DIP switch 1 has been switched to
manual! This option affects the light channel. For a detailed
description of fully automatic/semi-automatic mode, please refer
to chapter 7 "Functions".
12
: the lighting will then remain
DIP switch 3: Standard/corridor function:
oN/oFF = standard function
The lighting can also be switched on and off using an external
button.
oN = corridor function
The lighting can only be switched on using an external button.
DIP switch 4: Adjusting the sensitivity
The device is set to maximum sensitivity "S-max." in the factory
settings. If the switch is set to "S-min.", the level of sensitivity is
reduced. This setting is recommended if undesired switching occurs
due to interference sources, such as hot air streams.
7 • FUNCTIONS
Fully automatic mode – not in pulse mode!
The light channel will switch on automatically, depending on the preset
light value and detection of movement. This will remain on for as
long as movement is detected and as long as the ambient light value
does not exceed the preset light value. If no further movement is
detected, the time setting starts. The channel can also be manually
switched on or off using the S1 button. The device is preset to fully
automatic mode.
Semi-automatic mode for light channel
Switched ON/OFF manually using the S1 button. This lighting will
remain switched on for as long as movement is detected and as long
as the ambient light value does not exceed the preset light value.