Appendix A (Intermittent Pilot & Valve Kit) - Genesis INFINITY DESIGNER CLEAN FACE Série Manuel D'installation Et Guide De L'utilisateur

Table des Matières

Publicité

8.0 LABEL INFORMATION (continued)
This appliance is equipped with a three prong (grounding) plug for your protection against shock
hazard and should be plugged directly into a properly grounded three prong receptacle. Do not cut or
remove the grounding prong from this plug.
Cet appareil est équipé d'un à trois broches (terre) pour votre protection contre les risques de choc
électrique et doit être branché directement dans une prise à trois broches récipient. Ne pas couper ou
This appliance must be properly connected to a
venting system in accordance with the
manufacturer's installation instructions.
This is a direct vent appliance.
This appliance must be installed in accordance
with local codes, if any; if none, follow the
National Fuel Gas Code, ANSI Z223.1/NFPA
54,or the Natural Gas and Propane Installation
Code, CSA B149.1.
WARNING: Improper installation, adjustment,
alteration, service, or maintenance can cause
injury or property damage. Refer to the
manufacturer's manual provided with this
appliance. For assistance or additional
information consult a qualified installer,
service agency, or the gas supplier.
WARNING
Electrical Grounding Instructions
AVERTISSEMENT
Instructions à la terre électrique
retirer la broche de terre de cette fiche.
Page 50 of 55

Publicité

Table des Matières
loading

Produits Connexes pour Genesis INFINITY DESIGNER CLEAN FACE Série

Ce manuel est également adapté pour:

Infinity-60

Table des Matières