Genesis INFINITY DESIGNER CLEAN FACE Série Manuel D'installation Et Guide De L'utilisateur page 36

INNER GLASS PANEL INSTALLATION.
Carefully angle the front glass up into the top of the fireplace then lower into bottom glass channel. Lightly tighten
the 3 thumb screws at the bottom. Install 3 thumb screws lightly to hold the top of the glass.
OUTER GLASS PANEL/DOOR INSTALLATION.
Replace the inner louvers and the side panels before installing the outer glass.
Installation of the outer sides and front glass is the same. The outer glass panel with the glass support strip on, fits
up into 2 clips at the top of the fireplace as shown in the diagram below. Once top is in the clips push the bottom of
the glass in and slide down until it locks into the brackets at the top, tighten the thumb screws lightly. Make sure the
glass is installed properly before tightening the thumb screws.
Thumb screws
Do not operate this appliance with the glass removed, cracked or broken.
Replacement of the glass should be done by a licensed or qualified service person.
For use with glass certified with the appliance only

Do not use any substitute materials

Do not abuse glass by striking

Ne faites pas fonctionner cet appareil avec le verre retiré, fissuré ou cassé.
Le remplacement du verre doit être effectué par un technicien agréé ou qualifié.
• Pour utilisation avec du verre certifié avec l'appareil uniquement
• N'utilisez aucun matériau de substitution
• Ne pas abuser du verre en frappant
Thumb screws
Page 36 of 55