Table des Matières
Publicité
3.3.10 FAN ACCESSIBILITY / FAN ACCESSIBILITÉ
TURN THE MAIN GAS & POWER OFF TO FIREPLACE BEFORE COMMENCING ANY WORK ON THE
FIREPLACE THIS SHOULD BE DONE BY A LICENSED, CERTIFIED GAS INSTALLER
TURN LE PRINCIPAL GAZ ET MISE HORS TENSION AU FOYER AVANT DE COMMENCER TOUT
TRAVAIL SUR LA FOYER CELA DEVRAIT ETRE FAIT PAR UNE LICENCE, VOTRE FOURNISSEUR DE
THE 3 FANS IN THIS FIREPLACE (TWO IN THE FRONT AND ONE IN THE MIDDLE AT THE BACK) ARE
CONNECTED TO A HI/LOW THERMODISC, THE UNIT CAN NOT BE OPERATED WITHOUT THE FANS
GOING AS THE GLASS TEMPERATURE WILL EXCEED THE ALLOWABLE STANDARD OF 172F
LES 3 VENTILATEURS DE CE FOYER (DEUX À L'AVANT ET UN AU MILIEU À L'ARRIÈRE) SONT
RACCORDÉS À UN THERMODISQUE HAUT / BAS, L'UNITÉ NE PEUT PAS FONCTIONNER SANS QUE
LES VENTILATEURS PUISSENT DÉPASSER LA NORME ADMISSIBLE DE 172F DEGRÉS.
1/. Remove the air intake louver at the front of the fireplace
2/. Remove the outer glass as per instructions on page 35
3/. Remove the inner louvers
4/. Remove the fan ducts as shown in diagram above right
5/. Lift the fan out, fans are attached to the metal floor of the fireplace with heavy duty magnets as
shown below.
6/. Once removed from the floor the fan will slide out through the opening.
7/. When replacing fans make sure they line up totally with the fan ducts once the fan ducts are put
back into place. This will ensure the air is properly circulated between the 2 glass panels to maintain
the outer glass temperature as certified.
8/. To replace fan and reassemble the fireplace go in reverse order from steps 7 through 1.
GAZ
DEGREES.
SEE DIAGRAM BELOW.
VOIR SCHÉMA CI-DESSOUS.
280
Page 39 of 55
Publicité
Table des Matières
