Gas Valve Access - Genesis INFINITY DESIGNER CLEAN FACE Série Manuel D'installation Et Guide De L'utilisateur

Table des Matières

Publicité

The pictures above show the electrical box that controls the fan, the power cord attached and the strain relief
connected to the box. / Les photos ci-dessus montrent la boîte électrique qui contrôle le ventilateur, le cordon
d'alimentation fourni et le réducteur de tension connecté à la boîte.
3.3.11 GAS VALVE ACCESSIBILITY / ACCESSIBILITÉ ROBINET DE GAZ.
TURN THE MAIN GAS & POWER OFF TO FIREPLACE BEFORE COMMENCING ANY WORK ON
THE FIREPLACE THIS SHOULD BE DONE BY A LICENSED, CERTIFIED GAS INSTALLER
TURN LE PRINCIPAL GAZ ET MISE HORS TENSION AU FOYER AVANT DE COMMENCER
TOUT TRAVAIL SUR LA FOYER CELA DEVRAIT ETRE FAIT PAR UNE LICENCE, VOTRE
1/. Remove the outer louver and the outer front glass.
2/. Remove the 2 thumbscrews that hold the valve in place and the valve will lift up to remove the
connected gas pipe and pilot.
3/. The IPI (control box) will just lift out. Be careful when lifting out as you may have to remove some
wires off the box.
4/. The fan module will also lift up and out. Be careful when removing this module as the wires are
attached to the underside of the module.
BE CERTAIN TO CHECK FOR GAS LEAKS AT ALL GAS CONNECTIONS AFTER REINSTALLATION OF VALVE.
IL EST INDISPENSABLE DE VÉRIFIER LES FUITES DE GAZ A TOUS LES CONNEXIONS DE GAZ APRÈS LA
FOURNISSEUR DE GAZ
WARNING
AVERTISSEMENT
RÉINSTALLATION DE LA VANNE.
Page 40 of 55

Publicité

Table des Matières
loading

Produits Connexes pour Genesis INFINITY DESIGNER CLEAN FACE Série

Ce manuel est également adapté pour:

Infinity-60

Table des Matières