Table des Matières
Publicité
New and Extended IEEE-Bus Commands
The new firmware was extended by the following IEEE-bus commands:
• Additional command for active limit lines.
• Additional power measurement standard.
• Selection of Trace Averaging Method.
• Additional detector.
• Additional command for firmware update via IEC/IEEE bus interface.
• Additional parameter PHOLd for TRACe:DATA command.
:CALCulate<1|2>:LIMit<1...8>:ACTive?
This command queries the name of all activated limit lines. The names are output in alphabetical
order. If no limit line is activated, an empty string will be output. The numeric suffixes in
CALCulate<1|2> and LIMit<1 to 8> are not significant.
Example:
Features:
:CALCulate<1|2>:MARKer<1...4>: FUNCtion:POWer:PRESet NADC | TETRA | PDC | PHS | CDPD |
This command selects the settings for power measurement of one of the standards.
Example:
Features:
Mode:
TCDMa
TD-SCDMa
The selection of a standard influences the parameters weighting filter, channel bandwidth and
spacing, resolution and video bandwidth, as well as detector and sweep time.
1088.7490.01
":CALC:LIM:ACT?"
*RST value:
-
SCPI:
device-specific
"CALC:MARK:FUNC:POW:PRES NADC"
*RST value: -
SCPI:
device-specific
A-F
FWCDma
FW3Gppcdma
F8CDma | R8CDma | F19Cdma |
R19Cdma | M2CDma | D2CDma |
FO8Cdma | RO8Cdma | FO19CDMA
| RO19CDMA | TCDMa | NONE
G
|
RWCDma
|
RW3Gppcdma|
E-10
|
Publicité
Table des Matières
