Declaration Of Conformity; Changing The Tool - Bosch PSE 180 E Notice Originale

OBJ_BUCH-746-001.book Page 16 Tuesday, March 17, 2009 10:45 AM
16 | English
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 04.02.2009
1 609 929 N88 | (17.3.09)
Assembly
Before any work on the machine itself, pull
the mains plug.

Changing the Tool

When changing the application tool, wear
protective gloves. Remove the blade cover
6 for extra-sharp blades only for working.
Danger of injury when touching the sharp-
edged application tools.
Inserting (see figure A)
For selection of the application tools, see "Rec-
ommendations for Application Tools", page 17.
Press and hold the tool-lock button 5. With the
working edge facing downward, insert the appli-
cation tool (e. g. blade 1) to the stop into the
tool holder 2 as shown in the figure.
Release the tool-lock button 5. Pull the applica-
tion tool out of the tool holder 2, until it can be
heard to engage.
Check the tight seating of the application
tool/accessory. Incorrect or not securely fas-
tened application tools/accessories can
come loose during operation and pose a haz-
ard.
For extra-sharp blades, do not remove the blade
cover 6 until now.
Removing
Mount the blade cover 6 before removing extra-
sharp blades.
To remove the application tool, press the tool-
lock button 5 and pull out the application tool.
Clean the shank end of the application tool each
time after removing it.
Bosch Power Tools