Installation With The Isofix Platform; Seat Selection - KIDDY Evolution Pro 2 Manuel D'utilisation

EN
of the infant carrier (fig. 14). Make certain that the belt clip is in the
correct position. Now tighten the belt system (fig. 15). Make sure that
the belt is not twisted (fig. 15)!
The infant carrier is in the optimum position when the rear line at the
shell is at a 90° angle (vertical) to the horizontal line (fig. 15).
Some vehicles are fitted with so-called retractor locks.
With this, the automatic recoiling of the belt can be blocked,
which makes a more solid installation of the Evolution Pro 2
possible. Read your vehicles' owner manual for more infor-
mation on this feature or ask your authorised workshop.

7.2 Installation with the Isofix platform

7.2.1 Seat selection

Read up all the necessary information about the use of
child restraint systems in your vehicle owner's manual.
With the Isofix platform, the child restraint system Evolution Pro 2
can be installed in any seat in a vehicle that is fitted with Isofix an-
chors.
However, you must refer to the included vehicle type list with regard
to seat selection in your vehicle. The latest version of the vehicle type
list is always available for download at:
www.kiddy.de/typelist_isofixbase.
Rear-facing child restraint systems may never be used
with an activated front airbag!
Traces of use or discolouration can appear on some vehicle seat cov-
ers made from sensitive materials (e.g. velour, leather etc.) if car seats
or platforms are used. To avoid this we recommend to place a seat
cover shield or protection mat underneath the product.
14