Using The Newborn Inlay; Using The Sunshade; Buckling / Unbuckling Of The Baby; Loosening The Belt System - KIDDY Evolution Pro 2 Manuel D'utilisation

EN
Never use the Evolution Pro 2 in the reclined position in a vehicle. The
reclined position is intended for use outside the vehicle only.

5.2 Using the newborn inlay

The Evolution Pro 2 is equipped with a comfort inlay for newborns.
This inlay ensures a more level position of your baby in the infant car-
rier. This comfort inlay may only be used for babies up to the age of
6 months (fig. 3). To remove the inlay, open the buckle and remove
the inlay from the shoulder belts.
Premature babies: A special inlay for premature babies, which offers
a significantly better seating and reclined position, is available as an
accessory.

5.3 Using the sunshade

To extend the sunshade pull the hood towards the foot end of the
car seat. To retract the sunshade, push towards the head end of the
car seat.

6. Buckling / Unbuckling of the baby

6.1 Loosening the belt system

Turn the carry handle in to the carry position. Before you can adjust
the height of the shoulder belts, the belt system must be loosened.
For this purpose, keep the central adjuster pressed in the front un-
der the seating area (fig. 4, no. 1), and pull the shoulder belts (fig. 4,
no. 2) out.

6.2 Adjusting the height of the belt system

Open the front cover at the head end of the infant carrier by slightly
pressing the hooks upward (fig. 5, no. 1), now the cover opens (fig. 5,
no. 2). Now turn the height adjuster handle 90° clockwise (fig. 6, no. 1)
and pull the handle outward (fig. 6, no. 2), then move it into the desired
11