Use In The Vehicle; In-Vehicle Installation With Seat Belt; Seat Selection; Installation Steps With The Seat Belt - KIDDY Evolution Pro 2 Manuel D'utilisation

7. Use in the vehicle

7.1 In-vehicle installation with seat belt

7.1.1 Seat selection

Read up all the necessary information about the use of
child restraint systems in your vehicle owner's manual.
The Evolution Pro 2 child restraint system can be installed on any seat
of vehicles equipped with a 3-point belt system (fig. 11).
If you want to install the child restraint system in the pas-
senger seat, the airbag must be deactivated or you will
have to use a different seat.

7.1.2 Installation steps with the seat belt

WARNING
1. Place the Evolution Pro 2 facing the rear and with
the handle in the carry position on a seat without an
active front airbag and with a 3-point belt (fig. 12).
2. Before starting the journey, please always make
sure that the harness is put on and tightened cor-
rectly.
Pull the vehicle seat belt out and feed the lap belt through both lap
belt guides and press the safety belt lock tongue into the buckle
(fig. 13) with a clearly audible click. Check that everything is locked
into place. Tighten the lap belt (fig. 13). Now place the shoulder belt
around the infant carrier and feed it through behind the front cover
EN
13