Troubleshooting - Bartscher FA092M00 Manuel D'installation

ENGLISH
7.

TROUBLESHOOTING

The information below is provided to recognize
and repair any failures that may occur when
operating the appliance.
Problem
Gas smell.
The ignition flame does not start.
The igniting flame continuously
GB
goes out.
The ignition flame burns, but the
igniter does not ignite the burner.
Yellow flame.
It is difficult to rotate the burner
control knob.
The oven does not reach the
preset temperature.
Some of the failures can be repaired by the user,
others require thorough specialist knowledge.
Such problems may be solved exclusively by the
qualified personnel.
Cause
The smell is sometimes
released when extinguishing
the flame.
The spark ignition does not
work.
Air in the pipes in connection
with the long downtime.
The thermal element is not
sufficiently hot.
The burner is contaminated or
moist.
Damaged gas valve.
Damaged operational
thermostat.
The safety thermostat tripped.
10
Solution
Close the gas valve and ventilate the
room.
Check operation of ignition devices.
Ignite the flame manually.
Extend the ignition process.
Check the thermostat. Inspect a
relevant protection device.
When problem persists
contact the service company
Clean the burner and leave for
drying. When problem
persists contact the service
company.
Contact the service company.
Replace the part.
Contact the service company.
Wait for the oven to cool down.
Then reset the safety thermostat.