Remote Activation Of Commandable Outputs Free Of Charge - Urmet 1068 Série Mode D'emploi

The Figure 4 - AND - OR zones, demonstrates the use of AND - OR with the zones, where each zone has a room in
common with another zone
Notice how the alarm signals of the room in common (Room B) are strongly influenced by the logical combination
between zones Z1 e Z2, while the ones not in common behave traditionally.
2.4.5

Remote activation of commandable outputs free of charge

If the control panel is equipped with a GSM module and the GSM responder has been enabled, a valid SIM card can be
used to make activations remotely with no additional costs.
This function is based on the Caller ID of the telephones calling to carry out a quick activation of the programmed
commandable outputs. During the programming, the commandable outputs are associated with a cell phone number
memorized in the control panel (one of the ones used to send the alarms and other functions).
IMPORTANT!
The same telephone number may command multiple outputs. Just one output can be commanded by multiple
telephone numbers.
The operating principle is the following:
1. The GSM number of the control panel is called using the telephone number memorized.
2. The call is ended before 3 rings to avoid costs.
3. All the associated commandable outputs are activated: the pulsed ones for about one second (typical application of
a gate opener), commutable ones or bistable ones change status and remain active until they are deactivated by
sending the relative command via SMS.
4. To confirm reception of the command, the control panel calls the number that originally called for a few seconds.
This phone call must not be answered in order to avoid having the cost charged to the control panel SIM card.
DS1068-017
.
The icon visualises when the alarm is set off in case of an intrusion in the armed zones.
Figure 4 - AND - OR zones
23 LBT20717