Technoline WS6462 Mode D'emploi page 41


To reset the maximum and minimum temperature and humidity, press and hold down the "MEM" button about 2
seconds. This will reset all minimum and maximum data recorded to the current displayed values.
Note:
If the temperature reading is below ranges, the LL.L will be displayed. If the temperature reading is above ranges, the
HH.H will be displayed.
Outdoor Temperature alert setting

Press and hold down the " " button for 2 seconds until the icon for the temperature alert starts to flash

The icon of upper limit of the temperature alarm starts to flash. Use the "▲" and "▼" buttons to set the required
maximum temperature. Press " " to confirm your setting.

The icon of the lower limit of the temperature alarm starts to flash. Use the "▲" and "▼" buttons to set the required
minimum temperature. Press " " button to confirm your setting and to end the setting procedure
Temperature and frost alert

Press " " button to activate or deactivate the remote temperature alert, When the remote temperature alarm is
activated, the temperature alarm icon is displayed in the remote sensor bar
41