Optional Accessories; First Use; Adjusting The Intensity - NOVAFON DAS Manuel D'utilisation

2.3.2. Ball attachment
The ball attachment can be used for smaller areas and targeted
treatment. It is supplied as standard and also available as a spare
part.

2.3.3. Optional accessories

On our website you will find additional attachments for various treat-
ment goals. There is also a charging stand and USB cover caps for
your battery-powered NOVAFON device.
NOTE: Depending on your country the appliance might be addition-
ally equipped with a second power plug with country specific con-
nectors. These are available as spare parts, too.
3. OPERATION

3.1. FIRST USE

Charge the device fully before using it for the first time (section 3.3).
Switch on the NOVAFON device by pressing the on/off button once.
The device starts at 100 Hz ( ) by default. Pressing the button again
decreases the frequency to 50 Hz ( ). The current frequency selection
is indicated by the LED display (frequencies). Press the button a third
time to switch off the device.

3.2. ADJUSTING THE INTENSITY

Adjust the intensity by pressing the Intensity setting button repeatedly.
You can select between three intensity levels: light ( ), medium ( )
and strong ( ). The intensity level is indicated by the LED display
(intensity). The device always starts at the lowest intensity level ( ).
This also corresponds to the NOVAFON treatment recommendation,
i.e. starting with a low intensity and gradually increasing it according
to need and personal comfort.
NOTE: The best vibration is achieved when the device is operated
without additional contact pressure. If your device switches to a low-
er level by itself – or you're unable to increase the intensity – this is
probably because your battery level is low. If this is the case, please
recharge your device.
3.3. CHARGING
To charge the device, only use the included power adapter and USB-C
cable or the NOVAFON Charging Stand (not included). To charge the
device, first connect the cable to the device or to the charging stand
and then to the power adapter suitable for your power connection.
Only then plug the mains adapter into the socket. Charge the de-
vice until the charge display (LED) no longer flashes. Do not use the
NOVAFON device during charging. As soon as the LED display no
longer flashes, the NOVAFON device is fully ready to use. The device
has a low battery display. If the charge display (LED) starts flashing
rapidly, you can continue using your NOVAFON device for another
10 minutes. The device then switches off automatically. If you use
the charging stand for charging, make sure to place the appliance
carefully on the USB port. When removing, hold the charging stand
down and pull the device out carefully. The device is charging when
the display (LED) lights up. Avoid twisting the appliance in the