Cleaning And Care; Interior - After Microwave Cooking; Interior - After Convection, Mix Or Broil Cooking - hestan KMWC24 Mode D'emploi

CLEANING AND CARE

DISCONNECT THE POWER CORD BEFORE CLEANING OR LEAVE
THE DOOR OPEN TO INACTIVATE THE MICROWAVE OVEN
EN
EXTERIOR
The outside surface is painted. Clean the
outside with mild soap and water; rinse and
dry with a soft cloth. Do not use any type of
household or abrasive cleaner.
DOOR
Wipe the window on both sides with a damp
cloth to remove any spills or spatters. Metal
parts will be easier to maintain if wiped
frequently with a damp cloth. Avoid the use
of spray and other harsh cleaners as they may
stain, streak or dull the door surface.
TOUCH CONTROL PANEL
Care should be taken in cleaning the touch
control panel. If the control panel becomes
soiled, open the microwave oven door
before cleaning. Wipe the panel with a cloth
dampened slightly with water only. Dry with
a soft cloth. Do not scrub or use any sort of
chemical cleaners. Close the door and touch
the
STOP/CLEAR
INTERIOR - AFTER MICROWAVE
COOKING
Cleaning is easy because little heat is generated
to the interior surfaces; therefore, there is
no baking and setting of spills or spattering.
To clean the interior surfaces, wipe with a
soft cloth and warm water. DO NOT USE
ABRASIVE OR HARSH CLEANERS OR
SCOURING PADS. For heavier soil, use baking
soda or a mild soap; rinse thoroughly with
hot water. NEVER SPRAY OVEN CLEANERS
DIRECTLY ONTO ANY PART OF THE
MICROWAVE OVEN.
INTERIOR - AFTER CONVECTION,
MIX OR BROIL COOKING
Spatters may occur because of moisture and
grease. Wash immediately after use with hot,
soapy water. Rinse and polish dry. Harder
to remove spatters may occur if oven is not
thoroughly cleaned or if there is long time/
high temperature cooking. If so, you may
wish to purchase an oven cleaner pad with
liquid cleaner within it —not a soap filled steel
pad—for use on stainless or porcelain surfaces.
Follow manufacturer's directions carefully and
be especially cautious not to get any of the
34
©2019 Hestan Commercial Corporation
DURING CLEANING.
pad.
liquid cleaner in the perforations on the wall or
ceiling or any door surfaces. Rinse thoroughly
and polish dry.
After cleaning the interior thoroughly, residual
grease may be removed from the interior ducts
and heater by simply operating the oven on
450˚F [232˚C] for 20 minutes without food.
Ventilate the room if necessary.
WAVEGUIDE COVER
The waveguide cover is made from mica so
it requires special care. Keep the waveguide
cover clean to assure good microwave oven
performance. Carefully wipe with a damp cloth
any food spatters from the surface of the cover
immediately after they occur. Built-up splashes
may overheat and cause smoke or possibly
catch fire. Do not remove the waveguide cover.
ODOR REMOVAL
Occasionally, a cooking odor may remain in the
microwave oven. To remove, combine 1 cup
water, grated peel and juice of 1 lemon and
several whole cloves in a 2-cup glass measuring
cup. Boil for several minutes using 100% power.
Allow to set in microwave oven until cool.
Wipe interior with a soft cloth.
TURNTABLE/TURNTABLE SUPPORT/
RACKS
The turntable, turntable support and racks can
be removed for easy cleaning. Wash them in
mild, sudsy water; for stubborn stains use a mild
cleanser and a non-abrasive scouring sponge.
They are also dishwasher-proof. Use top rack
of dishwasher for turntable support.
Foods with high acidity, such as tomatoes
or lemons, will cause the porcelain enamel
turntable to discolor. Do not cook highly acidic
foods directly on the turntable; if spills occur,
wipe up immediately.
The turntable motor shaft is not sealed, so
excess water or spills should not be allowed to
stand in this area.