Nice HSTT2 Instructions Pour L'installation page 6

N° times "Push" key is pressed
1
2
3
4
Control device
Keypad
Remote control
Control panel
Control panel (with one of
the 16 radio controls
configured as "PULSE")
Control panel ((with one of
the 16 radio controls
configured as "ON-OFF")
• To memorise control devices on the receiver, see Table 5 and proceed as follows:
01. Press and hold "Push" (fig. 1) for at least 1 second, then release: the led emits one flash every 2 seconds
(timed interval = 20 seconds).
02. To modify the timed value, press the Push key briefly the same number of times as the required timed set-
ting (Table 4): the led flashes as envisaged for the specific setting;
03. On the control device, perform the procedure as described in: "Action to memorise command";
04. The led remains lit for 2 seconds to confirm memorisation. If the device has already been memorised, the
led flashes quickly for approx. 1 second.
05. To memorise other devices, repeat point 03 within 20 seconds; when this time elapses, the programming
phase terminates automatically.
4.3 – Deleting devices memorised on the receiver
All devices memorised on the receiver can be deleted as follows:
01. Press and hold "Push" (fig. 1) for at least 1 second, then release;
02. Press and hold "Push" for at least 4 seconds: the led flashes quickly for approx. 4 seconds to indicate
completed deletion of the memorised devices.
5 - DISPOSAL
As in installation, also at the end of product lifetime, the scrapping operations must be performed by qualified
personnel. This product comprises various types of materials, some of which may be recycled and others
must be disposed of; seek information on the methods of recycling or disposal as envisaged by local legisla-
tion for this product category. Some product parts may contain pollutant or hazardous substances; if disposed
of, these could harm the environment and personal health.
As indicated by the symbol alongside, disposal of this product in domestic waste is strictly pro-
hibited.
Separate the waste into categories for disposal according to the methods envisaged by current
legislation in your area, or return the product to the retailer when purchasing a new version.
Local legislation may envisage serious fines in the event of abusive disposal of this product.
4 – English
Led signal
1 flash - 2 s pause.
2 flashes - 2 s pause.
3 flashes - 2 s pause.
4 flashes - 2 s pause.
Table 5 - Timed type memorisation mode on HSTT2N
Receiver output
Preceded by a code of 1 to 4 digits:
▼ ▲
Key = ; Key =
Key Step-step mode command
Key Step-step mode command
Key (if configured as command key)
control in Step-Step mode
▼
On activation: command
Remote commands "On" or "Off":
Step-step mode command
Not used
Table 4
Timed mode
20 seconds
40 seconds
1 minute
2 minutes
Action to memorise command
Enter a code of 1 to 4 digits then press
key and
Press for 10 seconds
Press for 10 seconds
Press for 10 seconds
Disarm the control panel
(with a suitable device)
On the control panel, perform the radio
control configuration procedure;
select "PULSE" and press OK
simultaneously