Nice HSTT2 Instructions Pour L'installation page 7

6 - TROUBLESHOOTING... (troubleshooting guide)
• The commands are not performed and, immediately after powering up the control panel, the led does
not flash: check that the receiver is powered correctly; power must be present between terminals 5 and 6.
If powered correctly, there may be a serious fault. In this case, replace the receiver.
• Commands are not performed: ensure that the control device is memorised correctly on the receiver;
repeat the memorisation procedure if necessary. If a device is already memorised, this is indicated by quick
flashes for one second, in this case the memorisation procedure is not repeated.
• Activation of the pushbutton for the Step-Step input does not perform the commands: check the elec-
trical connection of the pushbutton and press the button to check that mains power is present on the input
(between terminals 4 and 6).
7 - TECHNICAL SPECIFICATIONS receivers HSTT2L and HSTT2N
WARNINGS: • All technical specifications stated in this section refer to an ambient temperature of 20°C (±
5°C). • Nice S.p.a. reserves the right to apply modifications to products at any time when deemed necessary,
maintaining the same intended use and functionality.
■ Power supply: 120 or 230 Vac, 50/60 Hz, limits: 100 ÷ 255 Vac
■ Maximum output power: 1000 W/500 VA for Vn = 230 V, 600 W/600 VA for Vn = 120 V
■ Reception frequency: 433.92 MHz
■ Radio encoding: Nice HS
■ Maximum device memory capacity: 64 on HSTT2L; 32 on HSTT2N
■ Radio range: 100 m in open field free of disturbance or approx. 20m inside buildings (*).
■ Protection rating: IP 20 (with container intact)
■ Operating temperature from - 20 to + +55 °C
■ Dimensions / weight: 40 mm x 18 mm x 32 mm / 20 g
(*) The range is strongly influenced by other devices operating on the same frequency with continuous trans-
missions that interfere with the receiver.
2
HSTT2L
3
HSTT2N
English – 5