Set­t­ing Up­ Vco; Installing The Backup Batteries - Ameriphone VCO Mode D'emploi

Set­t­ing up­ Your­ VCO
There are three steps involved in
setting up your VCO.
• Insert four AA rechargeable
NiCad batteries for back-up in
case of AC power outage.
• Decide if you want the phone
to sit on a desk or hang on the
wall.
• Connect the telephone
components.
Inst­alling t­he bac­kup­ bat­t­er­ies
If there is a power outage, the
VCO will operate for 4 - 8 hours
with four AA rechargeable NiCad
batteries (not included). If the
phone is not in use, the batteries
will stay charged for several months.
Insert 4 AA
batteries
here
Press in
here with a
tip of a pen
to open
battery
compartment
Figure 3 - Accessing the Batteries
To Inst­all New bat­t­er­ies:
Connec­t­ing for­ Desk or­ Wall mount­
Set the dial mode switch to T (tone)
if you have touch tone service. Set
the switch to P (pulse) if you have
rotary dialing.
MANUAL
AUTO
1. Slide open the battery
compartment cover on the
bottom of the telephone
(Figure 3). You may need to
press the tip of a pen into the
opening under the battery
door or with the tip of a pen.
2. Install four fresh AA
rechargeable NiCad
batteries. Be sure to match
the battery polarity as
imprinted on the base of the
compartment. (The "+" and
" " symbols).
E
N
G
L
I
S
H
7