Ameriphone VCO Mode D'emploi page 10

Set­t­ing up­ Your­ VCO
Deskt­op­ Use:
1. Connect the telephone line
cord and the handset cord
to the telephone as shown
in Figure 4.
2. Plug the AC adapter into
an electric outlet and into
the telephone as shown in
Figure 4.
3. Lift the handset and listen
for a dial tone. The phone
is ready to use.
Line Cord
Figure 4 - Connecting the Components
For­ Wall mount­ing
1. Slide the handset hook out
of the base as shown in
Figure 5 and reverse its
position so that the hook
points up and will hold the
handset when you hang up.
8
Handset
(Curly)
Cord
AC Adapter
Figure 5 - Reversing the Hook
2. Insert the tabs of the phone
base into the slots in the lower
position of the base as shown
in Figure 6. Push the mounting
bracket in and down firmly
until it snaps into place.
Figure 6 - Mounting Bracket
3. Locate a desired wall phone
jack near an AC outlet and
hold phone upright.
4. Plug the short phone line
cord into the wall outlet as
shown in Figure 4.
for Wall Mounting