VOLTCRAFT VC-86 Notice D'emploi page 31

Before measuring, check the measuring line for
damage such as, for example, cuts, cracks or
squeezing.
Defective measuring lines may no longer be used!
Danger to life!
To guard against injury through the measuring prods
on the pen-type there is a protection cap. This pro-
tection cap can be inserted when it has been remo-
ved into the safe-keeping opening (11) on the front.
Measuring prod selection
On the pen-type multimeter, the measuring prod can be replaced
simply by the enclosed 70 mm second tip This is used fo merasure-
ment on lower lying measuring points.
Screw the measuring prod off in the anticlockwise direction and
replace it with the long measuring prod.
The enclosed crocodile clamp can be screwed on the the black
measuring line.
Make sure when measuring the measuring prods
that all voltage sources have been removed from the
measuring device
31