Cleaning And Maintenance; Problems And Solutions - EUROM Vento 3D Mode D'emploi

Speed
OSC ( ef tand right)
OSC (Up and down)

Cleaning and maintenance

Switch the fan off and remove the plug from the socket if you wish to clean the
device or perform maintenance.
The fan only needs general, exterior maintenance. Dust it regularly with a soft cloth
or duster or use a vacuum cleaner with a soft brush to clean. If it is very dirty,
open the grille and clean grilles and blades using a soft, damp cloth and a mild
household cleaning agent. Dry everything thoroughly and allow the fan to dry
properly before reassembling and using again. Ensure that water does not come
into contact with anything other than the grille and blades. Never rinse or spray the
fan!
In order to prevent material discolouration or deformities, never use aggressive or
corrosive (cleaning) products.
If the fan is to be stored at the end of the season, repack in its original packaging:
this offers the best protection. Store it in a safe and dry place that is not subject to
extremes of heat or cold.

Problems and solutions

The fan blades do not rotate even though the device is switched on
 Is the plug in the socket?
 Is there power to the socket?
 Is the blade blocked, e.g. by damage, a deformity on the grille or a foreign
object?
There is strange noise when starting
 Check if there are any burrs around the edges of the blades.
Setting fan speed
1=Low
2=Medium
3=High
4=Turbo
Automatic oscillation: swiveling counter-clockwise and
clockwise
Automatic oscillation: swiveling up and down
The fan can swivel simultaneously up and down and
counter-clockwise and clockwise
23