Switching On The Device; Removing Weeds; Transport; Storage - Kärcher WRE 4 Battery Mode D'emploi

Switching on the device

You must press the unlocking button to en-
able the power switch (safety function).
Only then can the device be switched on
via the power switch.
1. Press the unlocking button.
2. Press the power switch at the same
time.
The device starts up, the unlocking but-
ton can be released and the device con-
tinues running.
3. Release the power switch.
The device stops.

Removing weeds

1. Always guide the device with slow
movements over the surface to be
cleaned, at a slight angle without apply-
ing any pressure. Do nor guide the de-
vice flat over the surface.
Illustration L
2. Work on stubborn weeds multiple times
slowly.
3. Hold the device at the side of the second
handle when cleaning joints so that it is
slightly titled. Please note that loose ma-
terial in the joint may also be removed.
Note
Please note that the device only removes
weeds at the surface. It does not remove
the roots.
The gentle nylon brush is capable of re-
moving a wide range of weed types from
and between almost any hard surface. The
cleaning results can however vary depend-
ing on external influences (ambient humid-
ity, ground moisture and ambient tempera-
ture).
ATTENTION
Risk of damage
Do not scrub with the device or use the pro-
tective cover for scraping. This may dam-
age the device

Transport

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transportation.
18
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during

storage.

Correct storage of the device

Store the device by hanging from the eye in
the handle. You can also alternatively place
the device on the edge of the protective
cover.
ATTENTION
Risk of damage to the brushes
Do not store the device standing on the
brushes.

Care and service

Changing the bristle strip

Note
The bristle strip must be replaced when the
bristles show signs of wear.
1. Remove the battery pack from the de-
vice.
2. Screw open the handle lock of the brush
holder and remove.
3. Pull out worn out bristle strip and the re-
moval aid.
4. Press the new bristle strip section by
section into the holder and latch into
place (see "Installation").
5. Fit the handle cover and screw closed.
Replacing the protective
WARNING
Risk of injury from flung particles
Use the weed remover only with an intact
protective hood.
The protective cover must be replaced
when it shows signs of wear such as cracks
or fractures.
1. Remove the bristle strip.
2. Release the lock on the protective cover
with a flat-blade screwdriver.
Illustration N
3. Pull the protective cover away to the
rear.
4. Fit the new protective cover and latch
into place.
English
Storage
cover