General Notes; Illustrations And Descriptions In These Operating Instructions; Intended Use; Environmental Protection - Kärcher T 1 T-Racer Surface Cleaner Mode D'emploi

General notes

Read the original instructions before us-
ing the device for the first time and act in
accordance with it. Keep the original in-
structions for future reference or for future owners.
Illustrations and descriptions in
these operating instructions
Illustrations and descriptions in these operating instruc-
tions may differ from the scope of delivery and equip-
ment for your T-Racer.
Note
Subject to technical changes without notice.

Intended use

The T-Racer can be used with all Kärcher Home & Gar-
den high-pressure cleaners of the K2 / K3 classes.
For devices manufactured up to 1991 you require an ad-
ditional adapter (see "Accessories and spare parts").
The T-Racer is ideally suited for cleaning floor and wall
surfaces of various different materials such as tiles,
stone, concrete, plastic and wood.
Only use the T-Racer in private households.

Environmental protection

The packing materials can be recycled. Please
dispose of packaging in accordance with the en-
vironmental regulations.
Electrical and electronic devices contain valua-
ble, recyclable materials and often components
such as batteries, rechargeable batteries or oil,
which - if handled or disposed of incorrectly - can
pose a potential danger to human health and the envi-
ronment. However, these components are required for
the correct operation of the device. Devices marked by
this symbol are not allowed to be disposed of together
with the household rubbish.
Working with detergents may only be performed on
watertight surfaces with connection to the waste
water sewage system. Do not allow detergent to enter
waterways or the soil.
Notes on the content materials (REACH)
Current information on content materials can be found
at: www.kaercher.de/REACH

Accessories and spare parts

Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.

Scope of delivery

Check the contents for completeness when unpacking.
The scope of delivery for your equipment version is
shown on the packaging. Please contact your dealer if
any accessories are missing or in the event of any ship-
ping damage.

Safety instructions

CAUTION
● Do not use the device when persons are in the vicinity
of the cleaning head.
● Switch the high-pressure cleaner off and disconnect
the T-Racer from the high-pressure gun after finishing
cleaning work and before performing any work on the
T-Racer.
● Do not trigger the high-pressure jet at the high-pres-
sure gun until the T-Racer is on the surface to be
cleaned.
● Recoil danger. Keep proper footing and hold the high-
pressure gun and extension tube firmly.
● Maximum water temperature 40°C (please observe
the instructions for your high-pressure cleaner).
Note
● Be sure to always adhere to the safety instructions for
your high-pressure cleaner and the locally applicable
regulations and directives.

Symbols on the device

Risk of injury! Never reach under the
edge of the T-Racer during operation

Device description

For the illustrations, refer to the graphics page
Illustration A
Extension tube
1
Casing
2
Adapter with bayonet connector
3
Bristle crown (T2 only)
4
High-pressure nozzle
5
Rotor arm
6
Note
One-time installation. The adapter can no longer be re-
moved.
Illustration B
1. Fit the adapter into the opening in the housing.
2. Turn the adapter clockwise until it latches into place.

Extension tube installation

Note
Ensure that the device components are tightly connect-
ed on installation.
Illustration C
1. Plug the bayonet into the mounting.
2. Turn the extension until it latches into place.
Repeat the procedure for all further extension tubes.
Note
The extension tubes can be used with all Kärcher ac-
cessories.
Note
For optimum cleaning results, do not operate the high-
pressure cleaner in the Eco mode.
Remove coarse dirt from the surface to be cleaned (e.g.
by sweeping) before using the device to avoid damage
to the T-Racer.
English
DANGER

Installation

Operation

Cleaning floors
5