Description Of The Unit; Start-Up; Operation - Kärcher IVR-L 100/30 Sc Mode D'emploi

Symbols on the device
Marking the maximum permissible fluid
level
See chapter Checking the filling level dis-
play.
ATTENTION
Risk of damage to the device
Leaking water due to the maximum fluid
level being exceeded.
Drain the device before the maximum fluid
level is reached.

Description of the unit

See graphics page for illustrations
Illustration A
Drain hose
1
Maximum filling level mark
2
Liquid container
3
Push handle
4
Suction hose connection
5
Filter
6
Mains cable
7
Suction head
8
Suction head crane grommet
9
Power switch
10
Gauge
11
Suction head lock
12
Screw plug
13
Deflector plate
14
Lower the liquid container lever
15
Chassis
16
Accessory holder
17
Steering rollers with parking brake
18

Start-up

See graphics page for illustrations
1. Bring the device into the working posi-
tion.
2. If necessary, secure the device using the
parking brake.
3. Ensure that the suction head is fitted
correctly.
4. Insert the suction hose into the suction
hose connection.
Illustration B
14
5. Plug the desired accessory onto the suc-
tion hose.
See graphics page for illustrations
1. Plug the mains plug into the socket.
2. Switch on the device using the power
switch.
Illustration C
3. Start vacuuming.
Suction process
Note
Only immerse the accessory halfway when
vacuuming liquids to encourage sufficient
air.
A gauge is mounted on the front of the de-
vice that shows the vacuum intensity(see
chapter Description of the unit).
 Clean the filter at a vacuum of less than
100 mbar or replace (see chapter Re-
placing the filter).
Checking the filling level display
See graphics pages for illustration
Illustration D
Note
The red marking on the drain hose shows
the maximum permissible filling level.
ATTENTION
Risk of damage to the device
The liquid container will overflow within a
few seconds of filling.
Constantly check the filling level in the liq-
uid container when filling large quantities of
liquid.
Emptying the liquid container
See graphics page for illustration
1. Switch the device off and disconnect it
from the power supply.
English

Operation

Gauge