Device elements
1 Mains cable with mains plug
2 Main switch
3 Suction device
4 Suction hose holder
5 Suction hose
6 Single-disc machine, not included in the
scope of delivery
7 Suction ring
8 Nameplate
9 Exhaust filter
10 Cover
11 Motor protection filter
12 Grid of the motor protection filter
13 Main filter basket
14 Fleece filter bag
15 Filter cover latch
16 Filter cover
17 Suction support (exterior)
Colour coding
The operating elements for the cleaning
–
process are yellow.
The controls for the maintenance and
–
service are light gray.
Initial startup
Figure 1:
Attach the suction ring to the cleaning
head of the single-disc machine.
Figure 2:
Fasten the suction cup to the push han-
dle.
Figure 3:
Connect the suction cup and the suc-
tion ring with the suction hose.
Fasten the suction hose to the suction
hose holders.
Plug the mains plug in the socket of the
single-disc machine, located at the bot-
tom side of the handle.
Caution
Risk of damage! If the suction decreases,
immediately turn off the motor.
Turning on the Appliance
Switch on the appliance at the main
switch.
Switch on the single-disc machine.
Turn off the appliance
Switch off the single-disc machine.
Note:
The suction cup can remain switched on. It
is then simultaneously switched on and off
with the single-disc machine.
After each operation
Remove the suction ring from the appli-
ance.
Empty main filter basket if necessary.
Use a moist cloth to clean the appli-
ance, the accessories and the cable af-
ter use.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
Risk of damage. Remove the suction ring
during storage of the appliance.
Remove the suction ring from the appli-
ance.
This appliance must only be stored in inte-
rior rooms.
– 3
EN
Operation
Transport
Storage
11