Device Description; Installation; Initial Startup; Information On Operating With A Battery Pack And Charger - Kärcher WRE 4 Battery Mode D'emploi

Device description

Illustration A
Rotating nylon brush
1
Brush protective cover
2
Pivoting cleaning head
3
Pivoting cleaning head unlocking button
4
Telescoping handle
5
Second handle
6
Power switch unlocking button
7
Telescoping handle unlocking button
8
Handle
9
Power switch
10
Mount for 18 V Battery Power battery
11
pack

Installation

1. Push the pipe provided with the cham-
fered side into the motor housing.
The pipe latches audibly into place.
ATTENTION
Risk of damage
The handle is pre-installed and set to the
shortest telescopic length. Do not
change the setting until the telescoping
handle is completely installed.
2. Insert the upper tube section into the
mount on the handle.
Illustration C
The pipe latches audibly into place.
3. Fit the power cable into the cable duct in
the telescoping handle from the bottom
to the top.
Illustration D
4. Push the second handle into the mount-
ing.
Illustration E
The pipe latches audibly into place.
5. Push the protective cover into the
mounting.
Illustration F
The pipe latches audibly into place.
6. Screw open the handle lock of the holder
and remove.
Illustration G
7. Press the bristle strip in a circle into the
brush holder and latch into place.
Illustration H
8. Fit the handle cover and screw closed.
Illustration I
16

Initial startup

Adjusting the device
Adjusting the telescoping handle
You can adjust the length of the device to
suit your requirements.
1. Press the unlocking button.
2. Adjust the telescoping handle as de-
sired.
Illustration J
Adjusting the cleaning head
You can adjust the angle of the cleaning
head to suit your requirements.
1. Press the unlocking button.
2. Adjust the cleaning head as desired.
Illustration K
Inserting the battery pack
ATTENTION
Dirty contacts
Damage to the device and battery
Check the battery mount and the contacts
for soiling and clean them as necessary be-
fore inserting the battery.
1. Push the battery into the mounting in the
device until it audibly latches into place.
Removing the battery
WARNING
Uncontrolled startup
Risk of injury
Remove the battery pack from the device
during work breaks and before carrying out
any service or care work.
1. Press the unlocking button.
2. Remove the battery from the device.
Information on operating with
a battery pack and charger
The battery pack is equipped with a display.
The following information is shown in the
display:
 Charging state
 Charging progress
 Remaining charging time
Note
The runtime adjustment is generated via
capacity switching!
 Error messages
English
Display