Inserting The Battery Pack; Recharging The Battery Pack - Dymo LabelManager 260P Guide D'utilisation

Inserting the Battery Pack

The battery pack included with your
label maker comes partially charged.
You do not need to charge the battery
pack before using your label maker for
the first time.
To insert the battery pack
Slide the battery compartment cover away from the label maker.
1
See Figure 2.
Insert the battery pack into the battery compartment.
2
Replace the battery compartment cover.
3
Remove the battery pack if the label maker will not be used for a long
NOTE
period of time.

Recharging the Battery Pack

A power adapter is included with your label maker for recharging the
battery pack.
The power adapter is only used for recharging the battery pack; the
NOTE
power adapter cannot be used to power the label maker.
To recharge the battery pack
Plug the power adapter into the power connector on the top of the
1
label maker.
Plug the other end of the power adapter into a power outlet.
2
6
Figure 2