Inserting The Battery Pack; Recharging The Battery Pack - Dymo LabelManager 360D Guide D'utilisation

Inserting the Battery Pack

The battery pack included with your label
maker comes partially charged. You do not
need to charge the battery pack before
using your label maker for the first time.
To insert the battery pack
Slide the battery compartment cover
1
away from the label maker. See Figure 2.
Insert the battery pack into the battery compartment.
2
Replace the battery compartment cover.
3
Remove the battery pack if the label maker will not be used for a long
NOTE
period of time.

Recharging the Battery Pack

A power adapter is included with your label maker for recharging the
battery pack.
The power adapter is only used for recharging the battery pack; the
NOTE
power adapter cannot be used to power the label maker.
To recharge the battery pack
Plug the power adapter into the power connector on the top of the
1
label maker.
Plug the other end of the power adapter into a power outlet.
2
6
Figure 2