Inserting The Battery Pack; Removing The Battery Pack - Dymo LabelManager Wireless PnP Guide De Démarrage Rapide

Inserting the Battery Pack

The label maker is powered using a rechargeable lithium-ion polymer (LiPo)
battery pack.
Make sure the USB cable is disconnected before handling the LiPo
battery pack.
To insert the battery pack
Press and pull to open the
1
side cover of the label maker.
Insert the battery pack into the
2
battery compartment as shown
in Figure 2.
Make sure to read the LiPo
Safety Precautions found on
page 12.

Removing the Battery Pack

Remove the battery pack when the
label maker will not be used for more
than seven days.
Make sure the USB cable is disconnected before handling the LiPo
battery pack.
To remove the battery pack
Unplug the USB cable.
1
Press and pull to open the side cover of the label maker.
2
Remove the battery pack from the battery compartment.
3
Make sure to read the LiPo Safety Precautions found on page 12.
Press
and pull
Figure 2
3