Connecting Using Hdmi - Pioneer DV-410V-K Mode D'emploi

Connecting the digital output
02
This player has coaxial-type digital audio
output for connection to an AV receiver.
Depending on the capabilities of your AV
receiver, you might have to set up this player to
output only digital audio in a compatible
format. See Digital Audio Out settings on
page 36 and refer to the operating instructions
that came with your AV receiver.
• Connect one of the COAXIAL DIGITAL
AUDIO OUT jacks on this player to a digital
input on your AV receiver.
AV receiver
P
B
P
R
HDMI OUT COMPONENT VIDEO OUT
DV-410V
For a coaxial connection, use a coaxial cable
(similar to the supplied video cable) to connect
the COAXIAL DIGITAL AUDIO OUT jack to a
coaxial input on your AV receiver.

Connecting using HDMI

(DV-410V only)
If you have a HDMI equipped monitor or
display, you can connect it to this player using
a commercially available HDMI cable.
The HDMI connector outputs uncompressed
digital video, as well as almost every kind of
digital audio that the player is compatible with,
including DVD-Video, Video CD, CD, WMA,
MP3, MPEG-4 AAC, DivX video and WMV.
14
En
To coaxial digital
input
DIGITAL AUDIO OUT
VIDEO OUT
AUDIO OUT L
COAXIAL
R
Y
S-VIDEO OUT
• Use an HDMI cable (not supplied) to
connect the HDMI OUT interconnect on
this player to an HDMI interconnect on a
HDMI-compatible display.
To HDMI
interconnect
VIDEO OUT DIGITAL AUDIO OUT
AUDIO OUT
P L
B
COAXIAL
R
P Y
R
HDMI OUT COMPONENT VIDEO OUT S-VIDEO OUT
DV-410V
The arrow on the cable connector body should
be face up for correct alignment with the
connector on the player.
Note
• This unit has been designed to be
compliant with HDMI (High-Definition
Multimedia Interface). Depending on the
component you have connected, using a
DVI connection may result in unreliable
signal transfers.
• When you change the component
connected to the HDMI output, you will
also need to change the HDMI settings to
match the new component (see HDMI
Out on page 36, HDMI Resolution on
page 37 and HDMI Color on page 37 to do
this). However, the settings for each
component are then stored in memory (for
up to 2 components).
HDMI-compatible display