Shimano Steps E6000 Série Mode D'emploi page 111

Other
Symptom
When pressing the switch,
two beeps sound, and the
switch cannot be operated.
Three beeps sound.
When using a electronic gear
shifting mode, I feel that the
level of assistance weakens
when the gears shift.
Sound occurs after gear
shifting.
A noise can be heard from
the rear wheel during
normal riding.
When you stop the bicycle,
the gear does not shift to
the position preset in the
start mode.
Cause / Possibility
Operation of the switch being pressed has
been disabled.
An error or warning is occurring.
This occurs because the level of assistance is
being adjusted to the optimum level by the
computer control.
Gear shifting adjustment may not have
been carried out correctly.
You may have been pressing the pedals too
strongly.
It is not a sign of a malfunction.
This occurs when a warning or error is
displayed on the cycle computer. Refer to
the section "Error messages on the cycle
computer" and follow the instructions
provided for the appropriate code.
It is not a sign of a malfunction.
Contact the place of purchase.
For mechanical gear shifting
Adjust the cable tension. For details, refer
to the Service Instructions for the derailleur.
For powered gear shifting
Contact the place of purchase.
If you press the pedals lightly, the gear
shifts more easily.
52
Remedy