Error Messages On The Cycle Computer; List Of Warnings - Shimano Steps E6000 Série Mode D'emploi

„ Error messages on the cycle computer
Warnings
This disappears if the error is fixed.
Display
Code
preconditions
The chain tension may
not have been adjusted
W031
or the crank may have
been installed in the
wrong position.

List of warnings

Display
Code
preconditions
The temperature of
W010
the drive unit is high.
The traveling speed
W011
cannot be detected.
The crank may be
W012 installed in the
wrong direction.
Operational restrictions
while warning is
displayed
The assist function is
not available. (However,
electronic gear shifting
will still function.)
Operational restrictions
while warning is
displayed
The level of assistance
may decrease.
The maximum speed up to
which power assistance is
provided may decrease.
(Power assistance is provided
up to 25 km/h in top gear.)
-
45
< SC-E6000 >
Remedy
Contact the place of purchase or bicycle dealer.
< SC-E6010 >
Remedy
Stop using the assist function until the temperature of
the drive unit drops.
If the situation does not improve, contact the place of
purchase.
Check that the speed sensor is properly installed.
If the situation does not improve, contact the place of
purchase.
Install the crank in the correct direction, then turn on
the power again.
< SC-E6010 >