Replacing Carbon Brushes; Optional Accessories - Makita RP1100 Manuel D'instruction

1
2
003799
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1
2
3
4
003696
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1. Lock nut
2. Templet guide
3. Router bit
4. Base plate
4
3
6 1. Router bit
2. Base
3. Templet
4. Workpiece
5. Templet guide
6. Lock nut
5
1. Limit mark
1
2
003704
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
•
Edge forming bits
•
Laminate trimming bits
•
Straight guide
•
Templet guides
•
Lock nut
•
Clear base plate (Center hole 2-1/2")
•
Wrench 27
•
Dust nozzle
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
8
1. Brush holder
cap
1
2. Screwdriver
or attachments
Only use accessory or
are