Troubleshooting - hestan KDW Mode D'emploi

TROUBLESHOOTING

Error codes and their meanings are listed on the following pages. The following instructions
will help you avoid error conditions and correct them if they occur.
IF THE PROGRAM FAILS, CHECK THAT:
• The dishwasher is connected to the power supply.
• There is no power failure.
• The water supply is open.
• The dishwasher door is properly closed.
IF WATER REMAINS INSIDE THE DISHWASHER, CHECK THAT:
• The drain hose is not kinked.
• The drain siphon is not obstructed.
• The dishwasher filters are not clogged.
IF THE DISHES DO NOT COME OUT CLEAN, CHECK THAT:
• The correct amount of detergent has been added.
• There is regenerating salt inside the special container.
• The dishes are loaded correctly.
• The selected program is suitable for the dish types and their degree of soiling.
• All the filters are clean and positioned correctly.
• The spray arm nozzles are not obstructed.
• There is no object obstructing the rotation of the spray arms.
• Run hot water faucet for a few minutes (until water gets hot) before starting dishwasher.
IF THE DISHES FAIL TO DRY AND REMAIN DULL, CHECK THAT:
• There is rinse-aid inside the special container
• The rinse-aid dispenser setting is correct.
• The detergent used is of good quality and has not lost its effectiveness (for example,
through incorrect storage such as with the container left open).
IF THE DISHES SHOW SIGNS OF STREAKING, STAINING, ETC. CHECK THAT:
• The rinse-aid dispenser setting is not too high.
IF THERE ARE VISIBLE TRACES OF RUST INSIDE THE TANK/UNIT:
• The tank is made of stainless steel and therefore any rust marks are due to external
elements (fragments of rust from the water supply, pots, cutlery, etc...) Special products are
commercially available to remove such marks.
• Check that the amount of detergent being used is correct. Certain detergents can be more
corrosive than others.
• Check that the cap of the salt container is securely closed and that the water softening
setting is correct.
IF AFTER PERFORMING THE ABOVE TROUBLESHOOTING INSTRUCTIONS THE PROBLEM
PERSISTS, CALL HESTAN CUSTOMER CARE.
ANY OPERATIONS PERFORMED ON THE APPLIANCE BY
UNAUTHORIZED PERSONS ARE NOT COVERED BY THE WARRANTY
AND ARE TO BE PAID FOR BY THE USER.
©2019 Hestan Commercial Corporation
EN
31