hestan KDW Mode D'emploi page 12

FEATURES AND CONTROLS
CONTROL PANEL DESCRIPTIONS
On/Off button
EN
1
Press to switch the appliance on or off.
Program indicator lights
2
These show which program is selected and whether there are any faults (Troubleshooting)
Program selection button
3 Press repeatedly/as needed to select the required program. Also used to select water hardness adjustment
mode.
Add Salt indicator light
4 When ON, indicates the appliance has run out of salt.
When FLASHING, indicates that the appliance is in water hardness adjustment mode.
Add Rinse Aid indicator light
5
When ON, indicates the appliance has run out of rinse aid.
Quick Wash option button
6
Press this button to start one of the quick wash programs (see table).
Quick Wash programs indicator light
7
Shows that one of the Quick Wash programs (6-10) will be run.
Energy Saver option button
8
Option to reduce energy consumption by opening dishwasher door at end of cycle for drying.
9 ON when the Energy Saver option has been selected.
Half Load option button
10
Press to select the half load option
11 ON when the Half Load option has been selected.
Sanitation indicator light
12
Shows that sanitation has been completed (see notes in the programs table)
Delay Start button
13
Press to delay the start of the program up to 24 hours
14 Information display
Crystal
Soak
10
©2019 Hestan Commercial Corporation
2 3
Super/
Daily Wash
Delicate Select
Sanitize
12 11 10
Energy Saver
1/2 Load
Sanitize
(CONT.)
4 5
ADD
Salt Rinse Aid
9 8 7 6
Quick Wash
14 13 1
Delay Start