Cleaning The Filter - hestan KDW Mode D'emploi

CLEANING AND USER MAINTENANCE
LOWER SPRAY ARM
To remove the orbital spray arm assembly (C), take hold of the lower arm (D) and pull the
orbital unit upward.
After cleaning, place the orbital spray arm in its seat and
push it down slightly until it clicks into place on the lower
spray arm. Then place the lower spray arm into its seat and
push it down slightly until it clicks into place.

CLEANING THE FILTER

Periodically remove the filter assembly (A) to inspect it. To
remove the filter, grip the tabs, turn counter-clockwise and
lift upwards.
The filter assembly consists of the outer micro-filter (fine
wire mesh) and a plastic center filter.
Push the center filter (B) from the underside to remove it
from the micro-filter.
To separate the two parts which make up the plastic center filter:
1. Find the arrows (C) on the sides of the
top piece.
2. Press the body of the filter
just below the arrows.
3. Remove the center filter by lifting it
upwards.
As needed, clean all parts of the filter
assembly under running water (at room
temperature), using a stiff brush.
After cleaning, reassemble and install the
filter assembly:
1. Join the two parts comprising the center
filter by pushing gently until they click
into place.
2. Insert the center filter into the micro-filter.
3. Place the filter unit (A) into its seat, turning it clockwise until it locks.
on each side
A
B
(CONT.)
C
D
2
1
C C
©2019 Hestan Commercial Corporation
EN
29