hestan KDW Mode D'emploi page 15

OPERATION
(CONT.)
INFORMATION DISPLAYED
Scheduled program duration
Remaining program time
Delayed start : 1 – 24 hours
Error message: Err
TURNING ON THE DISHWASHER
Press the On/Off button (Item 1, "CONTROL PANEL" on page 9) to start the dishwasher.
Then wait for one of the program indicator lights to turn on.
SELECTING AND STARTING A PROGRAM
1. For programs 1-5: press
the indicator light corresponding to the required program turns on (Items 2, same page)
2. Select options as needed ("1/2 Load", "Energy Saver", "Delay Start") and close the door. The
program will start after a few seconds. The indicator light will flash while the cycle is running
(see "PROGRAM RUN PROJECTION INDICATOR" on page 14).
SELECTING PROGRAMS 6-10
1. To run programs 6, 7, 8, 9, 10, select the corresponding standard program (1-5) and then press
the Quick Wash button (item 6 on page 10) .
• For example, to select program 6, press "Select" until "Soak" is indicated, then press the
"Quick Wash" button.
2. Proceed as with programs 1-5.
IMPORTANT
The door of the dishwasher must be closed within 4 seconds after use of the program selection
button (Select )for all functions (e.g. program selection, change, deletion, etc.).
If the door is not closed within 4 seconds, the selected program's indicator lights will flash rapidly
to indicate that the operation must be confirmed before the door is closed.
To confirm, simply press
to start/ resume the dishwasher.
The same applies if the dishwasher is opened with Delay Start set and the cycle not started (e.g.
to add more dishes): Select
delay countdown.
If the door of the dishwasher has not been closed or has been incorrectly closed, the washing
cycle will not begin. The "Program Run" light will be ON instead of flashing.
END OF WASH CYCLE
The end of the program is signaled by a short beep. Additionally, the indicator lights of the Daily
Wash and Super Sanitize wash programs will flash. The "Program Run" light will be OFF.
DISPLAY
Select (Item 3, "CONTROL PANEL" on page 9) several times until
Select once. The indicators will blink slowly and you can close the door
must be pressed before the door is closed, restarting the program
©2019 Hestan Commercial Corporation
EN
13