hestan KDW Mode D'emploi page 35

TROUBLESHOOTING
CODE
Soak Crystal
E6
Crystal
Soak
E7
Crystal
Soak
E8
Crystal
Soak
E9
Crystal
Soak
E11
Light off
If an alarm situation occurs, the dishwasher interrupts the current program and signals the
problem.
• Alarms E1, E2, E3, E4, E8 and E9 immediately terminate the current cycle. Alarms E5 and E6
interrupt the current cycle and, after the problem has been eliminated, resume the cycle.
• Alarm E7 is displayed at the end of the cycle, which however, is completed given that it does
not jeopardize the operation of the dishwasher.
• For alarms E9, E11, contact customer service.
TO CLEAR AN ALARM:
1. Open or close the door or switch off and back on again.
2. If the error clears, the dishwasher can then be programmed again.
If the problem persists, contact an authorized technical servicer.
(CONT.)
FAULT
Super/
Delicate Daily Wash
Sanitize
Super/
Delicate Daily Wash
Sanitize
Super/
Delicate Daily Wash
Sanitize
Super/
Delicate Daily Wash
Sanitize
Super/
Delicate Daily Wash
Sanitize
Light on
DESCRIPTION
Water pump-out malfunction
The appliance does not pump out the water or does so
incorrectly. Make sure the drain hose is not kinked or
crushed and that the siphon and filters are not clogged.
If the problem persists, contact Technical Service.
Turbine flow-regulator malfunction
The appliance is unable to precisely measure the
quantity of incoming water. Interrupt the current cycle
and turn off the dishwasher. Turn it back on again,
program a new cycle and press start. If the problem
persists, contact Technical Service.
Alternate washing system malfunction
Interrupt the current cycle and turn off the dishwasher.
Turn it back on again, program a new cycle and press
start. If the problem persists, contact Technical Service.
Water intake system malfunction
Contact Technical Service.
Wash motor pump malfunction
Contact Technical Service.
Light flashing
©2019 Hestan Commercial Corporation
EN
33