Troubleshooting Minor Problems - hestan KDW Série Manuel D'entretien

CLEANING AND USER MAINTENANCE
GENERAL WARNINGS AND RECOMMENDATIONS FOR
CORRECT MAINTENANCE (continued)
EN
Prolonged disuse:
• Run the soak program twice in succession.
• Unplug the power cord from the socket.
• Leave the door slightly opening order to prevent the formation of
unpleasant odors inside the washing tank.
• Fill the rinse-aid dispenser.
• Shut off the water supply tap.
Before starting the dishwasher after prolonged disuse:
• Check that there are no deposits of sludge or rust inside the water pipe.
If there are, allow the water to run from the water supply for a few minutes.
• Plug the power cord back into the socket.
• Reconnect the water intake hose and open the water supply again.

TROUBLESHOOTING MINOR PROBLEMS

In some cases it is possible to remedy minor problems by referring to the following
instructions:
If the program fails, check that:
• The dishwasher is connected to the power supply.
• There is no power failure.
• The water supply is open.
• The dishwasher door is properly closed.
If water remains inside the dishwasher, check that:
• The drain hose is not kinked.
• The drain siphon is not obstructed.
• The dishwasher lters are not clogged.
If the dishes do not come out clean, check that:
• The correct amount of detergent has been added.
• There is regenerating salt inside the special container.
• The dishes are loaded correctly.
• The selected program is suitable for the dish types and their degree of soiling.
• All the lters are clean and positioned correctly.
• The spray arm nozzles are not obstructed.
• There is no object obstructing the rotation of the spray arms.
If the dishes fail to dry and remain dull, check that:
• There is rinse-aid inside the special container
• The rinse-aid dispenser setting is correct.
• The detergent used is of good quality and has not lost its effectiveness (for
example, through incorrect storage such as with the container left open).
If the dishes show signs of streaking, staining, etc...check that:
• The rinse-aid dispenser setting is not too high.
30
©2018 Hestan Commercial Corporation
(continued)